Description: Insl-X Prime All White Flat Water-Based Acrylic Latex Primer 1 qt 32 oz AP-1000. 100% acrylic interior and exterior primer for all surfaces. Mildew resistant, quick dry, spatter proof with great flow and leveling. Formulated to suppress most stains. Recommended for: Use on new or previously painted wood, plywood, drywall, ceiling tile, Formica®, Masonite®, ceramic tile, cured plaster, and under wall coverings for easy positioning and removal. For exterior use on new or previously painted wood, aluminum, hardboard, vinyl siding, shingles, shakes, concrete, masonry, brick and non-ferrous metal surfaces. Limitations:- Apply when surface and ambient temperature is above 40 °F (4.4 °C) and below 90 °F (32 °C). - On hard, non-porous surfaces, such as glazed ceramics and non-ferrous metal, maximum adhesion and hardness may take 3-4 days to develop. - Not recommended for use on floor surfaces. Surface Preparation Surfaces to be painted must be clean, dry, and free of dirt, dust, grease, oil, soap, wax, scaling paint, water soluble materials, and mildew. Remove any peeling or scaling paint and sand these areas to feather edges smooth with adjacent surfaces. Glossy areas should be dulled. Drywall surfaces must be free of sanding dust. New plaster or masonry surfaces must be allowed to cure before applying base coat. Cured plaster should be hard, have a slight sheen and maximum PH of 10; soft, porous or powdery plaster indicates improper cure. Never sand a plaster surface; knife off any protrusions and prime plaster before and after applying patching compound. Poured or pre-cast concrete with a very smooth surface should be etched or abraded to promote adhesion, after removing all form release agents and curing compounds. Remove any powder or loose particles before priming. Wood substrates must be thoroughly dry. Caution: Smooth planed clapboards or siding must be sanded thoroughly to break the “mill glaze” allowing proper penetration and adhesion. Difficult Substrates: If the surfaces to be painted exhibit severe tannin or smoke staining, an alkyd based primer may be your best choice for conquering these severe conditions. Consult your retailer for further guidance. Glossy Surfaces – Prime-All® is formulated to be applied to hard to coat surfaces without the need for sanding, it is recommended that proper surface preparation still be completed to enhance adhesion properties. Surfaces such as Formica, ceramic tile and glossy painted surfaces should be properly deglossed. Once applied allow Prime-All™ to cure for approximately 3 to 4 days to achieve maximum resistance to scrape off. However, Prime-All® may be top coated with a quality latex or oil-based finish within 1 to 2 hours, depending on overall drying conditions. Stains – As a stain blocker, Prime-All® provides excellent stain blocking properties against common stains, such as water stains, tannin, smoke stains, graffiti, crayons, lipstick and finger prints. However, it is recommended to thoroughly clean the affected surface areas as directed above before application. Some difficult stains may require two prime coat applications.
Price: 12.75 USD
Location: Clute, Texas
End Time: 2025-01-30T19:35:58.000Z
Shipping Cost: N/A USD
Product Images
Item Specifics
Restocking Fee: No
Return shipping will be paid by: Buyer
All returns accepted: Returns Accepted
Item must be returned within: 14 Days
Refund will be given as: Money Back
Brand: Insl-X
Color: White
Compatible Material: Primer
Unit Quantity: 1
