Description: Ever tried to mount a square access point on a ceiling only to realize you didn't align the bracket and now it looks terrible? Most of the brackets available for mounting Ruckus access points only have screw holes and once you mount them in one place, they're done. This mount is adjustable. Put one screw through the fixed hole, align the bracket as best you can, then put a screw in the adjustable slot. Snug it down (but not too hard) and slide the access point on the mounting pegs. After you do that, you can still twist the access point body a bit and get it straight. These are 3D-printed from ABS or PETG and are meant for overhead or wall use on drywall or similar surfaces. Two standard drywall screws (with or without anchors) will fit flush in the bracket. The bracket allows for a total rotation of about 30 degrees in one direction and 15 in the other. I'm terrible at aligning things when I'm on a ladder and this is more than enough "wiggle room" to correct the skew. Designed and tested on an R610, but I expect this will work for R310, R510, R710, R350, R550, R650, R750 units and probably any other Ruckus units that have trapped-screw mounting holes 85mm (3-5/16") apart. If you're not sure, just message me. Includes two brackets. Color may vary.
Price: 10 USD
Location: Happy Valley, Oregon
End Time: 2024-07-19T00:01:02.000Z
Shipping Cost: 10.6 USD
Product Images
Item Specifics
Restocking Fee: No
Return shipping will be paid by: Buyer
All returns accepted: Returns Accepted
Item must be returned within: 30 Days
Refund will be given as: Money Back
Brand: Unbranded
Type: Adapter
